Difference between revisions of "Hardening Laws"
Jump to navigation
Jump to search
(Created page with "Plasticity materials implement their yield behavior by combining them with hardening laws. The material definition set the elastic equ...") |
|||
| Line 1: | Line 1: | ||
Plasticity [[Material Models|materials]] implement their yield behavior by combining them with hardening laws. The [[Material Models|material]] definition | Plasticity [[Material Models|materials]] implement their yield behavior by combining them with hardening laws. The [[Material Models|material]] definition sets the equation of state properties for the material and the selected hardening law determines the yield criterion. | ||
Hardening laws are assigned to materials within their material definition: | Hardening laws are assigned to materials within their material definition. When using [[NairnFEAMPM]] or [[NairnFEAMPMViz]], a a hardening law is added within a material definition block as follows: | ||
Material ID,name,type | |||
. | |||
plasticLaw (Law_Name or number) | |||
(Law Properties | |||
. | |||
. | |||
Done | |||
where | |||
<Material Type='#' Name='name'> | |||
. | |||
<plasticLaw>(Law_Name or number)</plasticLaw> | |||
(Law properties) | |||
. | |||
</Material> | |||
where the plasticLaw command selects the law (using the law name or number from the table below). The law selection is followed by commands to set any properties specific to that law. | where the plasticLaw command selects the law (using the law name or number from the table below). The law selection is followed by commands to set any properties specific to that law. | ||
Revision as of 11:00, 27 March 2013
Plasticity materials implement their yield behavior by combining them with hardening laws. The material definition sets the equation of state properties for the material and the selected hardening law determines the yield criterion.
Hardening laws are assigned to materials within their material definition. When using NairnFEAMPM or NairnFEAMPMViz, a a hardening law is added within a material definition block as follows:
Material ID,name,type
.
plasticLaw (Law_Name or number)
(Law Properties
.
.
Done
where
<Material Type='#' Name='name'>
.
<plasticLaw>(Law_Name or number)</plasticLaw>
(Law properties)
.
</Material>
where the plasticLaw command selects the law (using the law name or number from the table below). The law selection is followed by commands to set any properties specific to that law.