MPM Input Files

The following are all the possible sections for input XML files for running NairnMPM. When input files are validated using the DTD file (as recommended), the sections must appear in the specified order. Optional sections that are not needed may be omitted. A sample NairnMPM input file shows a sample calculation of two colliding disks.

XML File Overview

All input files for MPM calculations are XML files. When using NairnFEAMPM or NairnFEAMPMViz to set up calculations using a scripting language, the XML file is created for you by interpreting the scripting commands (and you can skip this section). If you are manually writing XML files, however, it must follow the structure defined in this section.

All XML command files for MPM calculations must begin with an XML declaration, an optional document type declaration, and the main input file tag and end with the corresponding closing tags. For MPM calculations, the global file structure is:

<?xml version='1.0'?>
<!DOCTYPE JANFEAInput SYSTEM "NairnMPM.dtd"
[
  <!ENTITY maxtime "1e-03">
  <!ENTITY width "100">  
]>
<JANFEAInput version='3'>
   ...
   (XML Command to define the calculation)
   ...
</JANFEAInput>

The !DOCTYPE element defines the file type and has the SYSTEM option to provide a path to a Document Type Definition (or DTD) file. The path is needed when you run the code with the validation option (-v), which is highly recommended. The required DTD file for MPM calculations is provided in the /input folder of the source code files.

The !DOCTYPE element can define any number of entities. These entities can be used elsewhere in the text of the XML file and they will be replaced by the text in the entity definition. For example, the above MPM file can use the entity &maxtime; and it will be replaced with the text 1e-03. Entities can define values that make it easier to read input XML files and easier to modify them for new calculations.

The remainder of the file is included withing a JANFEAInput block. The version attribute is currently not needed, but may be important in the future. To be consistent with the document definition in the DTD file, all elements with the JANFEAInput block must be entered in the ordered defined in the table of contents on this page. Elements that are not used can be omitted, but all needed elements must be in that specific order.

Defining Material Models

Each material point is assigned a material type. NairnMPM and OSUParticulas support numerous material models. For plasticity materials, each material type can choose from among a set of hardening laws. Finally, when using explicit cracks, the material points along the cracks can be assigned for various traction laws. The information on these options are in the following sections:

• Material Models
• Hardening Laws
• Traction Laws